USED  2018 DMG Mori i 30 V CNC Vertical Machining Center

Specifications: 

Taper

CAT 40 DUAL CONTACT 

X Axis Travel

15.7 inches

Y-Axis Travel

10.6 inches

Z Axis Travel

11 inches

Max Spindle Speed (RPM)

12000 

Spindle Motor

7.5 horsepower

Table-L

11.8 inches

Table-W

23.6 inches

Max Table Load

330 pounds

CNC Control

yes 

Type of CNC Control

DMG Mitsubishi Electric M730UM 

Tool Changer Capacity

14 

Rapid Traverse Rate (X/Y/Z)

2,440 (ipm) 

Tool Change Time

3 Seconds 

Dimensions

61.3W x 128.9D x 104.3H 

Weight

10846 pounds

Equipped With

Distance from table surface to spindle gauge plane:  9.4 - 20.5"

Max Tool Length:  10"

Max Tool Weight:  14 lb.

Max Feed Rate:  2,440 ipm

Number of Pallets:  2

Method of Pallet Change:  Rotation

Pallet Change Time:  2 seconds

FACTORY OPTIONS INCLUDED:  COST:  $135,000 over base machine

Standard spindle 12,000 min-1, 5.5/ 3.7 kW (#40)

Spindle Taper 7/24 Taper #40 (two-face contact)/ Grip CAT

Preparation for Center Through-spindle coolant system

Retention Knob: Special (Center-Through) (7/24 Taper #40)

Changing to Tapped pallets (2 pallets)

Interface for Hydraulic fixture (2 circuits x 2, 4 ports on each pallet)

Interface for Workpiece seating detection (2 lines x 2, 2 ports on each pallet)

Tool magazine door

Usable Coolant Type: Water-Soluble Coolant

Chip conveyor (rear discharge, magnet scraper type)

Interface for Through-Spindle Coolant System (7 MPa, Constant Pressure)

Coolant gun

Fixture washing coolant

Shower coolant

Mist collector (AFS 600), including stand (SK-OP)

Oil Skimmer (Belt type) (SK-OP)

Signal lamp 4 colors (Red, yellow, green, blue)

Automatic door (No Tape switch)

Interface for EtherNet/IP (SK-OP)

Interface for Robot (EtherNet/IP), Need to select EtherNet/IP Interface

Interface for Gage (EtherNet/IP), Need to select EtherNet/IP Interface (SK-OP)

High acceleration (including Dry anchor)

Spindle Head Cover

10 external M-codes (SK-OP)

Setting Unit inch

Multiple M codes in single block (Multi M code function)

Screen display English

MCC TMS

MAPPS Tool management system + Tool ID (MAPPS software only)

Tool ID system (Stand installed in MG)

Tool brackage detection(KEYENCE sensor PX-10CP)

Assembly fee for special option

DMQP: ChipBlaster M30/70 Unit - 8 gpm @ 1000 PSI 50 gal tank / cyclone filter (installed)

DMQP: ChipBlaster Sludge Settling Tank "Baffled settling tank for dirty coolant discharge: 35 gal capacity  **recommended with all cyclonic filters  (installed)