Maximum Swing-Side Head Below Table 68"
Maximum Swing-Side Head Above Table 60"
Max distance Turret Face to Chuck
Face 83 5/8"
*Maximum Distance Rail to Chuck
(2’ Extra Height Column)
Diameter with Built-in 4 Jaw Manual Chuck
In Geometric Ratio
Vert and Horiz Feed Can Be Engaged
To Give 45° Resultant Feed In Any Quadrant
Same Is True Of Rapid Traverse
Feeds Per Rev. Of Spindle .00065" to
Power Index Four Sided Turret Head,
Side Head with
4-Sided Hand Index Toolpost
Head On Cross Rail Equipped With 4 Sided
Turret With Power Index
Will Face Machine Capacity
Will Swivel 30° Right Or Left Of Center
Clearance Under Side Hd Slide to Chuck
Table Speed Range:
4.1 to 150 RPM
30 HP 3/60/220-440 Volt Motor and
Controls For Operation on 110 Volts
Angular Turning Attached for Turret Head
Newall DRO on Turret Head
Approximate 62,000 Lbs.
all changes in table speeds and power
feeds are controlled from the pendant. There are no
levers for shifting. Engagement of
feeds and rapid
traverse to side head and rail head in
all directions are
controlled from pendant. Turret
indexing is controlled
from the pendant.
156" L-R x 165" F-B x 216" Hi